Comments: Blynk Board Project Guide
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
If you've found an issue with this tutorial content, please send us your feedback!
I wish the overview had a listing of how all the virtual pins are mapped with the pre-loaded firmware. I found a listing here: https://github.com/sparkfun/Blynk_Board_ESP8266/blob/master/Firmware/BlynkBoard_Core_Firmware/BlynkBoard_BlynkMode.ino
Be interesting to monitor DC voltage say 5-30 volts?
I am finding The temp sensor on the board not at all accurate consistently measuring 85-89 degrees F. I wonder if its not measuring board Temp. How can I hook up a DHT 11?. Thanks
I also observed the on-board sensor was reporting a higher than ambiant room temperature. There probably isn't much that can be done about it, but overall the value proposition for the Blynk Board still makes it worthwhile IMHO.