Comments: SparkFun Auto pHAT Hookup Guide

Pages

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Member #1565689 / about 4 years ago / 1

    So, I need to have a power supply for the rpi AND a power supply for the Auto pHAT to run the motors ?

    It will not hurt either to have both plugged in at the same time ?

  • Member #691310 / about 4 years ago / 1

    If this Auto pHAT is mounted directly on a Raspberry Pi 3 B+ the Qwiic connector is behind the ethernet port. On the Raspberry Pi 4 B it looks like it would be behind the USB ports.

    • santaimpersonator / about 4 years ago / 1

      That is correct, the Ethernet jack is on the opposing side between those two versions of the Raspberry Pi.


If you've found an issue with this tutorial content, please send us your feedback!