Comments: ZX Distance and Gesture Sensor SMD Hookup Guide

≡ Pages

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Member #1643360 / about 4 years ago / 1

    Hi, I notice that the ZX sensor uses pins A4 and A5 for Arduino. I have another device running on pins A4 and A5. Is there a way to alter the library so that other analog pins are used instead of A4 and A5? Thanks!

  • Member #1418196 / about 7 years ago / 0

    Hi, I just received my ZX Gesture sensor. The sensor is does not respond when Z distance exceeds 10 inches. Is there any need for calibration or this is the expected behavior?


If you've found an issue with this tutorial content, please send us your feedback!