Comments: MicroView Digital Compass

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

dksmall / about 8 years ago / 2 /

It looks like there's an error with the breadboard picture for battery usage. Pin 15 of the microview has a red wire going down to the bus strip, but it plugged into the row used for GND, not VCC.
- AGlass0fMilk / about 8 years ago / 1 /
  
  Thanks for noticing that! The diagram has been fixed. It'd be very bad to short 5V to ground!

If you've found an issue with this tutorial content, please send us your feedback!