Comments: Qwiic VR IMU (BNO080) Hookup Guide
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
If you've found an issue with this tutorial content, please send us your feedback!
Hi, Does the Interrupt line for I2C also double for SPI?
Hi there, it sounds like you are looking for technical assistance. Please use the link in the banner above, to get started with posting a topic in our forums. Our technical support team will do their best to assist you.
That being said, please refer to page 48 of the datasheet.
Under Hardware Overview, I think the accuracies should be in units of m/s^2 instead of m/s. Based on Figure 6-12: BNO08X Performance, page 50, "1000-3927 - BNO080 Datasheet v1.6.pdf" from https://www.hillcrestlabs.com/downloads/bno080-datasheet
You're totally right, I've fixed it up. Thanks!
Hi there,
I have noticed an error in the documentation in the Hardware Overview. You have indicated that the I2C address pin is SO instead of SI.