Qwiic Pressure Sensor (BMP384) Hookup Guide
Contributors:
El Duderino
El Duderino 
Resources and Going Further
For more information about the SparkFun Pressure Sensor - BMP384 (Qwiic) check out the following resources:
- Schematics
- Eagle Files
- Board Dimensions
- Datasheet (BMP384)
- GitHub Hardware Repo
- BMP384 Arduino Library
Looking for inspiration for your next environmental sensing project? The tutorials below may help you get started:
Si4707 Hookup Guide
Instructions on hooking up to and communicating with the Si4707 Weather Band Radio Breakout using an Arduino.
SparkFun BME280 Breakout Hookup Guide
A guide for connecting the BME280 sensor to a microcontroller, and for using the SparkFun Arduino library.
RHT03 (DHT22) Humidity and Temperature Sensor Hookup Guide
Measure relative humidity and temperature or your environment with the RHT03 (a.k.a DHT22) low cost sensor on a single wire digital interface connected to an Arduino!
Wireless Remote Weather Station with micro:bit
Monitor the weather without being exposed to it through wireless communication between two micro:bits using the radio blocks! This is useful if your weather station is installed in a location that is difficult to retrieve data from the OpenLog. We will also explore a few different ways to send and receive data.