Comments: LiPo Charger Plus Hookup Guide
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
If you've found an issue with this tutorial content, please send us your feedback!
Since I didn't see it stated: to set the charge current, you connect the resistor between the two PROG holes. (I think there's no need to remove the existing 1K resistor if you're putting a smaller one on, since electricity uses the path of least resistance.) You don't have to try to solder on another SMD resistor by hand, phew!