Hookup

Good vibes only. Getting started with the Haptic Motor Driver.

An introduction to working with the Electret Mic Breakout Board.

Assembly Guide for the RedBot Kit. This tutorial includes extra parts to follow to go along with the RedBot Inventor's Kit tutorial.

This Experiment Guide offers nine experiments to get you started with the SparkFun RedBot. This guide is designed for those who are familiar with our SparkFun Inventor's Kit and want to take their robotics knowledge to the next level.

A Hookup Guide for the SparkFun Qwiic Button (Red) and SparkFun Qwiic Button Breakout. Goes over connecting the Qwiic Button to an Arduino microcontroller and using it with the Qwiic Button Arduino library.

This is an assembly guide for the SparkFun Flashlight Kit, a basic learn to solder kit.

The SparkFun Qwiic MultiPort adds additional ports to boards that have only one Qwiic port on their I2C bus. Once added, you can use it as a hub to add as many I2C devices to the bus as you need! You can also use the board as an alternative to a daisy chained configuration.

Get started with the Qwiic Ultrasonic Distance Sensor!

A quick introduction to the DS1307 RTC module and a hookup guide for the SparkFun Breakout.

Need to add more analog inputs for your project? Check out the Qwiic 12-bit ADC.

Add a high precision, digital temperature sensor to your projects using the TMP117 over the I2C!

The Qwiic RFID ID-XXLA is an I2C solution that pairs with the ID-LA modules: ID-3LA, the ID-12LA, or the ID-20LA, and utilizes 125kHz RFID chips. Let's take a look at the hardware used for this tutorial.

This guide will go over how to use the USB Type-C Power Delivery Board.

Ever wanted to prototype I2C components on a Pi? Now you can!

Your guide to commissioning, tinkering, and programming the SparkFun Photon RedBoard.

Use RealVNC to connect to your Raspberry Pi to control the graphical desktop remotely across the network.

Find out where you are! Use this easy hook-up guide to get up and running with the SparkFun high precision GPS-RTK NEO-M8P-2 breakout board.

The u-blox NEO-M8U is a powerful GPS units that takes advantage of untethered dead reckoning (UDR) technology for navigation. The module provides continuous positioning for vehicles in urban environments and during complete signal loss (e.g. short tunnels and parking garages). We will quickly get you set up using the Qwiic ecosystem and Arduino so that you can start reading the output!

An electric imp HUG! Provides an overview of the imp card and breakout. Both hardware and firmware subjects are covered.

An introduction to the RedBoard Turbo. Level up your Arduino-skills with the powerful SAMD21 ARM Cortex M0+ processor!

Learn how to get started with our fiber optics breakout boards

A short Hookup Guide to get started with the SparkFun MicroMod Input and Display Carrier Board

Get started interfacing your Qwiic enabled boards with your Raspberry Pi 400! SparkFun Qwiic pHAT Extension for the Raspberry Pi 400 provides you with a quick and easy solution to access all of the 400's GPIO, stack your favorite HAT right-side up, or connect a Qwiic-enabled device to the I2C bus (GND, 3.3V, SDA, and SCL).

Get started interfacing your Qwiic enabled boards with your Raspberry Pi. This Qwiic connects the I2C bus (GND, 3.3V, SDA, and SCL) on your Raspberry Pi to an array of Qwiic connectors.